Radiant Floor Heating in Connecticut Homes: Pros and Cons
Electric or hydronic radiant floors? How each works, where they fit, the honest drawbacks, and what to ask before heating a floor in a cold climate.
Radiant heating
Radiant heating warms the floor or the wall, and that surface warms the room — no radiators and no blowing air. We include it in new homes, additions, renovations and garages, designed for the rooms it has to heat.
There are two main kinds of radiant floor. Hydronic systems pump heated water from a boiler through tubing under the floor. Electric systems use heating cables or mats. In heating-dominated climates, the U.S. Department of Energy calls hydronic the most popular and cost-effective radiant choice; electric floors usually make sense only in special cases, such as an addition where extending the heating system is impractical.
Radiant heat has real advantages and real drawbacks. A slab responds slowly, floor coverings change the results, and adding it to an existing floor takes work. We talk through both before you decide.
Connecticut licenses electrical work and heating and piping work separately. Ask us who holds the license for each part of your system.
Which rooms, which floor coverings, and what heats the house today.
Hydronic or electric, floor or wall, and how it connects to the heat source.
A layout sized for the rooms. In existing homes, a look at the floor framing first.
Installation by the licensed trades the work requires, then startup and a review with you.
Every project follows our process. We don't publish prices or fixed time frames: both depend on your project, and we discuss them with you in writing.
Electric systems use heating cables built into the floor or mats under the floor covering. Hydronic systems pump heated water from a boiler through tubing under the floor. The U.S. Department of Energy says hydronic systems are the most popular and cost-effective radiant systems in heating-dominated climates, while electric floors are usually cost-effective only in special cases.
Sometimes. The Department of Energy describes installing tubing or cables under the subfloor between the joists, which usually means drilling through them. It also says an engineer should check the floor's carrying capacity if concrete adds weight. We inspect the floor framing before planning.
The Department of Energy says ceramic tile is the most common and effective choice. Vinyl, linoleum, carpet and wood can be used, but any covering that insulates the floor lowers efficiency.
A hydronic system has a boiler and pumps, so it needs regular service. Ask for a maintenance schedule for your system.
General information, not legal advice. Rules change — confirm with your town and the state before you build.